常见的问题
How to trigger the serial command (tethered scanners)
最后更新 2 years ago
Please follows the steps below:
3. Open HyperTerminal.exe on your PC.
4.Name the file and find the correct COM port of the scanner.
(You can find the COM port by checking the Control Panel → System → Device Manager)
5.Set the baud rate at 9600
6.Manually type #@//// into the HyperTerminal and press Enter
7.If the command works, you should hear a beep.
You can also set up other settings. For example, #@100207 will change the scan mode to Test Mode.
- Connect the scanner to the host computer via RS232
Set up the RS-232 interface by scanning the following barcodes:
3. Open HyperTerminal.exe on your PC.
4.Name the file and find the correct COM port of the scanner.
(You can find the COM port by checking the Control Panel → System → Device Manager)
5.Set the baud rate at 9600
6.Manually type #@//// into the HyperTerminal and press Enter
7.If the command works, you should hear a beep.
You can also set up other settings. For example, #@100207 will change the scan mode to Test Mode.