Frequently Asked Question

1. Update Firmware v1.04a
   
2. Scan the following barcodes to enter the setting mode:

Depending on the barcodes required, the following steps may vary slightly.
Here we use code 39 and EAN 13 as the barcode set for demonstration.

1. Set the first code type:
   
   
   1. For code 39, scan “4” and then “1” of Hexadecimal values
      
   2. Scan 4 zeros: “0000” of Decimal values ( = any code length)
      
   3. Scan 2 zeros: “00” of Hexadecimal values ( = no matching character required)
      
   4. Scan “F” twice (Hexadecimal values)
2. Set the second code type:
   
   
   1. For EAN13, scan “5” and then “0” of Hexadecimal values
      
   2. Scan 4 zeros: “0000” of Decimal values ( = any code length)
      
   3. Scan 2 zeros “00” of Hexadecimal values ( = no matching character required)
      
   4. Scan “F” twice (Hexadecimal values)
      

After specifying the settings, scan Validate → Enforce Output Sequence to apply the editor.

5. The barcode set operation mode should now be enabled.