Frequently Asked Question

Before checking the procedures below. Please make sure Device has already installed in UHF Gun.

• use USB cable or snap on to connect to your Device and put the Firmware file to the Download folder.

• Go to EZConfig, clicking the setting list bar on the left.

Note: The Standard FW must be upgraded to V1.18 before upgrading the Kernel to V1.02. Otherwise, the upgrade will fail, and the Uhf Gun will not be able to power on.

Step1: Upgrade User FW

• Find the “Update Firmware” then click it.

• Find the “Download/” path then click it.

• Find the UHF Reader User Firmware which you need to upgrade then click it.

• After clicking “OK” the system will start upgrading automatically

Step2: Upgrade Kernel FW

• Find the UHF Reader Kernel Firmware which you need to upgrade then click it.

• Find the “Download/” path then click it.

• After clicking “OK” the system will start upgrading automatically

Step3: Check Firmware Version

• After upgrading completed. Check the Firmware Version again to make sure upgraded successfully.

• Clicking the “Device Information”.

• Check your “Firmware Version” in Device Information