Frequently Asked Questions

How to set multicode configuration for 2D scanners
Last Updated 2 years ago

Applied Models: 1504A/ 1564A/ 1664/ 2504MR/ 2564MR

How to set the Multicode configuration:
1. Prepare the Multi-barcode pattern
2. Connect the scanner with PC and set it to VCOM mode; check the COM Port number on the PC
3. As the picture illustrated below, click the Scanning Mode drop-down menu to select "Multicode", and then click the "Multicode" button at the bottom of the tab.

image

4. Refer to below picture, click "Capture Image", type the correct COM port of the scanner. Then, you can use the scanner to capture the Multi-barcode pattern into ScanMaster.

image

5. The picture below illustrates: enclose each of the barcodes (step 1) in the captured image and specify the barcode type (steps 2 & 3). Please note that you need to repeat steps 1~3 marked on the picture below until all of the barcodes are set into ScanMaster.

image

6. Download the settings onto your scanner, saving the profile in the mean while.

Please Wait!

Please wait... it will take a second!